I have a 3458A with the S/N sticker missing.
The firmware revision is 9.2
Is there any way I can read the serial number of the instrument?
ID? only says HP3458A and obviously it does not understand SCPI language
Hi analogRF,
...try "*IDN?"
Good luck
Hi analogRF,
...try "*IDN?"
Good luck
like I said this instrument does not understand SCPI commands
Hello,
perhaps the EEVblog Metrology-Forum is a better place for this question.
Best regards
egonotto
Hi analogRF,
...try "*IDN?"
Good luck
like I said this instrument does not understand SCPI commands
same toughts
the keysight manual specify ID? and not IDN? for a id request, and it report only the model nothing more it seems,
It was asked in another thread here in the past
no SN sticker sound suspicious, these stickers don't remove themselves or fall off easily ?? is it an Fleabay purchase ?
no SN sticker sound suspicious, these stickers don't remove themselves or fall off easily
Especially on an item which lists at the price it does!
I have a 3458A with the S/N sticker missing.
The firmware revision is 9.2
Is there any way I can read the serial number of the instrument?
ID? only says HP3458A and obviously it does not understand SCPI language
Could you provide us a picture of the rear of your 3458A like this one from xDevs?
I'd also recommend to write xDevs a PM or send him an email. Perhaps he can provide you some help.
And I think egonotto is right, this thread should be in the metrology section.
This thread is continued in the eevblog Metrology forum