Hi there,
I just got a P2 Pro with a Macro Lens and YouTube decided to show me the T2S Plus
I was wondering.
Should I return the P2 Pro and get the T2S Plus instead?
The only reasons why I didn't do it so far are because I'm not sure if it's worse than the P2 Pro.
Apparently the P2 Pro has autofocus (I heard it in one review, but couldn't really find anything about it. My P2 Pro "calibrates" every few seconds with an audible click, so maybe that's it?
Whereas the T2S Plus doesn't, but instead of that it has that pretty handy manual focus lens.
Another thing that the T2S Plus has is the apparently smaller FOV (44,9° x 33,4° 20% smaller compared to the P2 Pro's 56° x 42,2°) and the lower temperature range. (450°C instead of 550°C), and it has more noise compared to the P2 Pro (NETD ≤60mK @25 ℃ vs ≤50mK @25 ℃).
I'm not sure if they both share the same sensor and chip though.
It does have the same 25hz though and the same resolution, and includes a gimbal like thing.
Am I overthinking this, should I just keep the P2 Pro? I did use the p2 pro for PCB work and immediately did find a small shorted resistor, but switching to the macro lens feels a bit tedious.
I only want to use the thermal camera for fault detection on boards, and maybe look at insulation of houses.
The t2s only thing that makes it kinda enticing to me is the manual focus and ability to get closer to the board, I wish they would sell something like that for the P2 Pro (which only has a fixed focus macro lens.)