Author Topic: Beamworks Spark100/400 help needed  (Read 1166 times)

0 Members and 1 Guest are viewing this topic.

Offline DeepblueTopic starter

  • Contributor
  • Posts: 12
  • Country: dk
Beamworks Spark100/400 help needed
« on: May 13, 2024, 02:50:38 pm »
Hi Guys,
I'm in need of some help and guidance with a Beamworks Spark 100 I have acquired. I'm stuck at creating a job and I'm hoping someone has experience with the Spark 100 / 400 software.
I do have the manual available, but I can't seem to get a job fully created to start soldering a test PCB.
Best case scenario would be if someone would make a guide-for-dummies to create a job and do a test run.
Maybe a Youtube video, but it seems no one has ever used these maschines as there is NO information available I can find.

Hope someone can help me out here. Thanks in advance.
2197063-0
 

Offline DeepblueTopic starter

  • Contributor
  • Posts: 12
  • Country: dk
Re: Beamworks Spark100/400 help needed
« Reply #1 on: May 15, 2024, 05:19:31 am »
No one ever worked with these? :o
 

Offline SMTech

  • Frequent Contributor
  • **
  • Posts: 853
  • Country: gb
Re: Beamworks Spark100/400 help needed
« Reply #2 on: May 15, 2024, 07:28:46 am »
Is that shocking? They're a pretty niche product of limited utility with a price tag that further limits the number of people that might choose one.
That said, there is a 400 listed on eBay right now and the listing suggests the seller is able to offer training at extra cost....
 

Offline DeepblueTopic starter

  • Contributor
  • Posts: 12
  • Country: dk
Re: Beamworks Spark100/400 help needed
« Reply #3 on: May 15, 2024, 09:06:20 am »
Thanks for the heads up on eBay. I will check it out  8)

I know these were expensive and very niche, but some should be out there? the two machine I have are labeled serial 1008 and 1009 :)
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf