Fluke application note about DMM test / calibration

• Fluke application note about DMM test / calibration
  Posted by Dr. Frank on 31 May, 2016 06:25
• Fluke just has sent me a nice application note: "A generic DMM test and calibration strategy".
  
  It can be found here: http://us.flukecal.com/node/19698
  
  This AN describes the basic building blocks of a DMM, and how to verify its performance.
  
  I used such a procedure, to evaluate the 34465A/470A, and to identify the errors of the 100V/1kV DCV ranges.
  
  https://www.eevblog.com/forum/testgear/keysight's-new-34465a-(6-5-digit)-and-34470a-(7-5-digit)-bench-multimeters/msg889215/#msg889215
  
  Frank
• #1 Reply
  Posted by Mickle T. on 31 May, 2016 11:55
• Ain't the same?

  ---

  A Generic DMM Test and Calibration Strategy.pdf
• #2 Reply
  Posted by Dr. Frank on 31 May, 2016 15:03
• Recycled, obviously, as Fluke recycles many DMM stuff from Wavetek / Datron.
  
  Frank
• #3 Reply
  Posted by enut11 on 01 Jun, 2016 06:32
• Quote from: Dr. Frank on 31 May, 2016 15:03

  Recycled, obviously, as Fluke recycles many DMM stuff from Wavetek / Datron.
  
  Frank
  

  
  Thanks for sharing. It was a good bedtime read...