[Stm32 Cube IDE] Programming without debugging?

[kgavionics]

Hello guys
I just switched from Keil uvision to STM32 CUBE IDE which has a simple option to program the MCU in very fast way , without debugging as opposed to Cube which launch a debugging session that takes about 1 min before it uploads the hex file to the MCU. .My question: Is there any option to for uploading the hex file without debugging in Stm32 Cube?
TIA

[langwadt]

1 minute?

[DavidAlfa]

Use "run" instead debug?

[Siwastaja]

Install openocd, run from command line, takes only seconds (although understanding how to use it would take a few hours first).

[nctnico]

Hello guys
I just switched from Keil uvision to STM32 CUBE IDE which has a simple option to program the MCU in very fast way , without debugging as opposed to Cube which launch a debugging session that takes about 1 min before it uploads the hex file to the MCU. .My question: Is there any option to for uploading the hex file without debugging in Stm32 Cube?
TIA

Disable auto-build before starting a run / debugging session. You can find this in the run / debug configuration setting.