« previous next »
Pages: [1]   Go Down

Author Topic: Can I program a microcontroller with universal programmer  (Read 1341 times)

0 Members and 1 Guest are viewing this topic.

Offline abdolahTopic starter

  • Regular Contributor
  • *
  • Posts: 63
  • Country: eg
Can I program a microcontroller with universal programmer
« on: January 20, 2025, 09:11:41 pm »
Hi guys
I bought the xgecu t48 universal programmer and I was wondering if I can programmer a microcontroller or plc with it
Or is it only for memory flashing?
Thanks for your time
Logged
 

Offline Ian.M

  • Super Contributor
  • ***
  • Posts: 14135
Re: Can I program a microcontroller with universal programmer
« Reply #1 on: January 20, 2025, 10:19:15 pm »
Did you read the device support list?
http://www.xgecu.com/MiniPro/T48_List.txt
if its not on the list you are out of luck.   
Logged
 
The following users thanked this post: abdolah

Offline mikerj

  • Super Contributor
  • ***
  • Posts: 3671
  • Country: gb
Re: Can I program a microcontroller with universal programmer
« Reply #2 on: January 21, 2025, 09:10:00 am »
PLCs are normally programmed over a USB or serial link connection.
Logged
 
The following users thanked this post: abdolah
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 

- - -
-->
EEVblog® Main Site EEVblog® on Youtube EEVblog® on Twitter EEVblog® on Facebook EEVblog® on Odysee