seeking a freescale HCS08 binary/hex debugger/disassembler

[kolonelkadat]

I was wanting to have a poke around the firmware on a mc9s08jm32 (Freescale). Sadly, my version of IDA doesnt have built in support for freescale processors.

Can anyone link me to a disassembler that supports the HCS08 processor? Preferably an  IDA plugin if possible. Id really appreciate it.

[amyk]

Writing your own doesn't look that hard...

[kolonelkadat]

I doubt its hard, but im also sure that one already exists since Freescale is listed as a supported cpu on th IDA website, but apparently not in whatever version im using.

I just really hate to reinvent the wheel, ya know?

[digsys]

That was my previous favourite processor series. I have heaps of tools for it, but I won't be back in the office for a
few hours. I'll let you know then.

[kolonelkadat]

right on man. I'd appreciate any cool tools you've got.

[digsys]

Sent you a PM

[codeboy2k]

oh me too please.. I have a desire to mess around with an old HCS08 board I have lying about

thanks

[digsys]

PM sent

[pund]

I too have been looking for an HCS08 IDA module.
Any chance I could get it as well?
Thanks.

[cae20452]

if already stay  me too please , thanks

[ale500]

Ghydra could also have something useful, but I haven't checked.

[Martinthemaker]

I'm also looking for a Freescale dissasembler/ decompiler