Author Topic: BLDC controller dummy load  (Read 5208 times)

0 Members and 1 Guest are viewing this topic.

Offline mazurovTopic starter

  • Frequent Contributor
  • **
  • Posts: 526
  • Country: us
    • nerpa
BLDC controller dummy load
« on: November 27, 2012, 04:58:25 am »
giving up trying to simulate back emf I built this dummy load over a Thanksgiving weekend. Very simple and works very well. Project details and link to video -> http://www.circuitsathome.com/measurements/dummy-load-for-brushless-motor-controller



With sufficient thrust, pigs fly just fine - RFC1925
 

Offline Shuggsy

  • Regular Contributor
  • *
  • Posts: 56
  • Country: us
Re: BLDC controller dummy load
« Reply #1 on: November 27, 2012, 06:33:34 am »
Looks beautiful and seems useful too from the video on your site.

Good job!
 

Offline sorin

  • Frequent Contributor
  • **
  • Posts: 299
  • Country: de
Re: BLDC controller dummy load
« Reply #2 on: November 27, 2012, 10:08:13 am »
Good job!
But big mistake in my opinion, you can not short the output. for 2 principal reason
1. the heat produced which should be more than 200W, so... overheating end destroying
2. the saturation of the magnetic field on the dummy load motor
 

Offline mazurovTopic starter

  • Frequent Contributor
  • **
  • Posts: 526
  • Country: us
    • nerpa
Re: BLDC controller dummy load
« Reply #3 on: November 27, 2012, 03:52:44 pm »
This thing actually works very well, see the video. The whole reason to have windings shorted is to generate the least amount of heat. I may put resistors in the future to make the load weaker but this will require adding a big fan to cool them down.

BTW, you can't saturate magnetic field, see this -> http://en.wikipedia.org/wiki/Saturation_(magnetic)
With sufficient thrust, pigs fly just fine - RFC1925
 

Online ejeffrey

  • Super Contributor
  • ***
  • Posts: 4871
  • Country: us
Re: BLDC controller dummy load
« Reply #4 on: November 27, 2012, 05:26:27 pm »
This thing actually works very well, see the video. The whole reason to have windings shorted is to generate the least amount of heat. I may put resistors in the future to make the load weaker but this will require adding a big fan to cool them down.

The power has to go somewhere.  If you short the windings, all of the power will be lost in the parasitic losses of the winding resistance.  External resistors will reduce the load on the windings, but also reduce the maximum torque.
 

Offline sorin

  • Frequent Contributor
  • **
  • Posts: 299
  • Country: de
Re: BLDC controller dummy load
« Reply #5 on: November 27, 2012, 06:19:37 pm »
Perpetuum Mobile...
black magic
 

Offline peter.mitchell

  • Super Contributor
  • ***
  • Posts: 1567
  • Country: au
Re: BLDC controller dummy load
« Reply #6 on: November 28, 2012, 08:03:32 am »
i've Always wondered how these fair compared to inverters for DC->AC conversion...
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 

- - -
-->