Yep two at once because I'm typically comparing my models against some reference which is usually some garbage broken vendor model. Characterizing what has changed if anything requires subjecting it to a battery of tests under various biasing conditions and whatnot.
Ah, OK.
Would it be better then, to have them better (or completely) isolated? Example, removing L3, L8, L9 and etc., and whatever ESR of V13 and V14, so they're on a voltage supernode. Or using separate sources, so, just two independent paths of 4th-order LPFs.
Oh yeah the gazillion labels are totally essential when there are numerous grounds. This is the greatly simplified version in which I've merely approximated actual analog delays with inductors. That gets rather complicated quickly.
To what end is that all simulating? Is this modeling a specific real environment, say? And do you have VNA measurements of that environment to match it up to..?
And yet there is none, which is in fact the key point to my entire question! Evidently SPICE is resolving this by implicitly solving some sort of differential equations there which is rather interesting. Normally a construction like this would not work.
Ah, OK. Well, I don't know about ngSpice specifically; perhaps there's some technical documentation out there? If nothing else, ask the devs?
I'm not too familiar with base SPICE, myself, as in actual implementation. Not sure offhand if that would lead to an ill-conditioned matrix, or, how/when dependent sources are put into the matrix calculation in the first place. NG has made a number of improvements (which, again, I know very little about), could very well be they have a solution for that, yeah.
Because as I've alluded to I'm simulating a "single supply" type of circuit in which all parts including signal source are incorporated into the supply currents etc. Transmission line models are quite good for imparting analog delays onto "small signals" but not very good for doing the same with the supply currents themselves. LRC networks are the easiest way to roughly approximate that. More complex behavioral circuits are another. Eventually you give up and move to a real field solver.
So this is to model some real-world environment? Would you not be better off assuming contiguous ground plane, and modeling supply inductance / trace length as whatever RLC or TL equivalent is suitable for the frequency range of interest?
I don't think there's a whole lot of value in modeling, like, distributed ground impedances. So long as the grounds are good locally, and any trace length between them is a reasonable TL as such. We can assume good shielding (by the plane) and concentrate on DM alone; CM is a matter for external purposes (i.e., leakage from the circuit), and maybe we need better shielding to realize that assumption, but that it's not dangerous to make such assumptions, given that we have the means to implement them (i.e., reserving enough space on the layout to get the desired isolation between traces or surroundings, to be able to add shields, etc.).
Mind, "distributed". That's different from local device ground/power, which may still need to be modeled: via/trace inductance, local bypass if applicable, etc. This can then be modeled as a 1-port in series between ideal ground and the device, and a 1- to 2-port to power (depending on how much of the board you want to model, i.e. including PSU, planes, etc.).
Oh you're the seventransistorlabs dude. Thanks for the spice page! I use some of those. Let my unclear schematics be revenge for making me decypher your damn netlists!

Alright, I'll give you that one.

Anything you especially wished for a schematic or description on, BTW? Have documented a couple of the more interesting ones, but if there's interest I can add more.
Tim