ClockBuilder Pro by Silab.

[MasterT]

I need to verify registers settings for Si5351, created with my own fast 27-bits approximation algorithm. Unfortunately, I can't run Silab's ClockBuilder Pro on my Linux.
Could someone be so kind, that can run software on Win. machine and post a few test arrays with reg. data?
Let say, Si5351A, CLK-0   PLLA , Multisynk-0 Integer Mode, XTAL
12.345 kHz,
 1 MHz,
123.456789 MHz
 

[ebclr]

Do atrial on remote Amazon desktop, there you can run windows remotely on your Linux and install sillabs software and run your self

[senso]

Virtual machine?

You can install Win10 without a key, it will just have the water mark on the bottom right corner..