Hi All
I am finally getting round to finishing the assembling of some more modules for my 2nd BB3 and have one that ia throwing an error message, I haven't managed to find a list of the possible error codes and explanations anywhere so thought I would ask on here.
The module in question is a DCP405 R3B3 and the message that I am getting is is "Ch1 IOEXP fault match detected" with a continuous rapid beeping and inability to close the message, this has also sometimes caused the BB3 to enter and exit standby repeatedly even though the power on self checks come back as okay.
Does anyone know what the code set criteria is for this fault code? I assume that it is one or more of the input signals to IC14 that it is moaning about but not sure which one.
For info incase it matters - I am using an R3B3 MCU with firmware V1.7.6
Thank you
Jem