thancks
please give me FMD's official programming manual.pdf
I Cannot download it from official website
1:For FT60F01x / FT60F02x (iclist 1 and 2), what exactly do you read to verify the ICID after entry? Please give the SFR/FCFG addresses and the expected byte values (like 0x00: 06; 0x09: 0A; 0x83: FF for iclist

.
2:For these iclists, what is done in the "page/bank select" step before the SFR read (the //set page? branch for iclist 1..7)? Which opcodes and values?
3:What are the exact FCFG addresses/offsets where the write delay and erase delay are stored, and how are the values encoded (units, scaling)?
4. How many words does UCFG have for FT60F01x and FT60F02x, and which are checksum/protection words? Is the "HW checksum" (UCFG7) computed over flash only, or flash plus UCFG?
5. How is EEPROM (data flash) read, written and erased? Please give the op 0xA mode values and the per-byte timing.
6. Is the flash write done word by word with the 1.5/2.5 ms delay, or is there a faster page/row write using the latch buffer (op 0x01 several times, then one 0x06)? What is the buffer size?
7. At entry, how long after VDD rises must the first 0x1CA3 word arrive (min/max)? Does VDD slew rate matter, and do the DAT/CLK lines need to be held low during power-up?
8. Is the 3.2 ms pre-key delay before each of the two 0x1CA3 words fixed, or is there a window?
9. Please describe the F-18 entry sequence (iclist 72/77/80/86) and the FT62F03x, FC1x, FDCx sequences in full, including bit widths of the $51 and $E words.