Electronics > Projects, Designs, and Technical Stuff
looking for a long gear/extruded spur gear
dequo:
I need a long gear for a project, im sure theres a name for what i want but i havent been able to find anything.
It needs to be like a cylinder with teeth going lengthways, the opposite of a worm gear almost. the rest of the project can be adapted to its pitch diameter etc. Preferably a diameter of 35mm and about 10cm long.
i have though of getting it custom made but im sure somebody would sell something like this..
GeoffS:
Look up timing belts or pulleys and you/ll find something like this:
is this what you're after?
dequo:
yeah pretty much that but it needs to be able to mesh properly with a spur gear. the thread on that looks more rectangular
RayJones:
Does the word "pinion" help?
DaveW:
How about this,
http://www.hpcgears.com/products/toothed_bar_stock.htm
HPC are very good, had them make some custom gears for me for robot wars, was surprisingly cheap
Navigation
[0] Message Index
[#] Next page
Go to full version