2215a oscilloscope No trace

[ifrrated]

Hi:

I have a 2215A scope with no trace. Beam finder works ok. All trigger settings appear correct.
Printing out service manual today.

Any suggestions as to where to start?  is this a common fail?

Thank you

[anachrocomputer]

First step, as always, is to check the power supply voltages. A bad or missing power supply voltage will send the CRT beam off the screen, and hence give the symptom that you report.

[tautech]

Hi:

I have a 2215A scope with no trace. Beam finder works ok. All trigger settings appear correct.
Printing out service manual today.

Any suggestions as to where to start?  is this a common fail?

Thank you

You might need this too:
http://www.sphere.bc.ca/test/tek-parts/troubleshooting-scopes.pdf