« previous next »
Pages: [1]   Go Down

Author Topic: 3D printing knobs?  (Read 653 times)

0 Members and 1 Guest are viewing this topic.

Offline AxtmanTopic starter

  • Regular Contributor
  • *
  • Posts: 181
  • Country: us
3D printing knobs?
« on: January 26, 2022, 06:56:08 am »
Does anyone here 3D print items? I am interested having someone print me about a dozen knobs for an old Univox guitar amplifier. Thanks.
Logged
 

Offline Swainster

  • Frequent Contributor
  • **
  • Posts: 259
  • Country: sg
Re: 3D printing knobs?
« Reply #1 on: January 26, 2022, 02:34:50 pm »
I do, but I'm based in Singapore. If you have no luck here then you could probably find someone closer on Reddit
Logged
 

Offline mag_therm

  • Frequent Contributor
  • **
  • Posts: 688
  • Country: us
Re: 3D printing knobs?
« Reply #2 on: January 27, 2022, 03:50:35 am »
Did you do a search for "NOS" knobs etc or try search generic "guitar amp knobs"?
I recently restored an old Bogen amp and found the original skirted  knobs available from more than one supplier.
like here:
https://www.surplussales.com/ShaftHardware/Knobs-10.html (there are other pages)
Logged
 

Offline george.b

  • Frequent Contributor
  • **
  • Posts: 383
  • Country: br
Re: 3D printing knobs?
« Reply #3 on: January 27, 2022, 04:12:12 am »
In the US you could try Shapeways or something, I guess?
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee