The problem is; HP 4261A LCR Meter.
Someone removed a board full of logic chips and with a Hot Air gun and took all the chips out. He heated the board so much that in some places it is burned a bit. With a TL866 II programmer I found almost 90% of the logic Ic's no good. I figure it is from over temp. The guy who did this installed IC sockets all over the PCB , so at least one good thing. I am still waiting for 3 IC's ( 93L34PC) and then I will be able to see if there is any other problems..
well, back to the drawing board.
Have a good one !