I'm facing a small emergency here - my TDK-Lambda GEN600-2.6 power supply failed when a 'lytic failed. The problem is that the supply can no longer sense it's own output voltage, so it ramps up until it hits the overvoltage protection. The fault is internal to the supply, and the meter shows the voltage ramping up. If I hook up an external meter, it reads the same as the front panel, i.e. the voltage is really going up.
Any help appreciated. I am in a crunch, so if I can get a service manual or schematic, maybe I can fix it. I already have the operating/programming manual, and it is not much help.
Thanks,
John