« previous next »
Pages: [1]   Go Down

Author Topic: Tektronix LA probe P6860 - Mechanical Fastener Question  (Read 910 times)

0 Members and 1 Guest are viewing this topic.

Offline rfdesTopic starter

  • Regular Contributor
  • *
  • Posts: 187
  • Country: us
Tektronix LA probe P6860 - Mechanical Fastener Question
« on: November 07, 2017, 10:30:16 pm »

Regarding the nut bars used with the P6860 probes and the adapters, does anyone happen know the screw size/pitch of the lock down fasteners?

I only have one nut-bar and one of the holes is stripped.  I was thinking of buying some steel 'key-stock' and drilling/tapping a set of holes.  I might even try filling the stripped hole with JB Weld epoxy and retapping.  I figure I have nothing to lose.  ;D

Logged
 

Offline lukier

  • Supporter
  • ****
  • Posts: 634
  • Country: pl
    • Homepage
Re: Tektronix LA probe P6860 - Mechanical Fastener Question
« Reply #1 on: November 07, 2017, 10:57:23 pm »
I don't know what's inside the nutbar, but for the PCB mounted probe scenario I bought the #2-56 PCB inserts (see Digikey 36-4871CT-ND) and they seem to work fine.
Logged
 

Offline rfdesTopic starter

  • Regular Contributor
  • *
  • Posts: 187
  • Country: us
Re: Tektronix LA probe P6860 - Mechanical Fastener Question
« Reply #2 on: November 08, 2017, 12:44:42 am »
Thanks... that's all I need to know! :D
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee