Hello everyone,
not sure if this is the right subforum or "Other Equipment & Products" would be better – feel free to move it.
A couple days ago, I’ve got an "YIHUA 938BD+" soldering station (picture below). The package came a without any duct tape and practically accessible to anybody. I check the accessories and just to be sure opened even the machine, since there was no sealing sticker present.
There is a mainboard marked "YH-NZLT2-V1.0" (picture below). Beside the terrible job of soldering and other things, I found a resistor place R18 to be
bridged with solder (without any resistor) (marked on picture) and
scratches on the board that obviously cuts a couple of lines on the board (marked on picture). These things made me worried and stopped me from powering it up.
I need help from someone who have this "YIHUA 938BD+" soldering station and can
confirm to me that those things are ok and should be there. Otherwise I will return this station back to the seller immediately. Unfortunately, I didn’t find any service manual on the internet.
Thanks anyone for help