Yeah no one posts it , found that others asked the same at other forums.
And not Easy to get one if not in US.
Connector should be Amphenol C 091 B
With crimp contacts (if I remember right).
Take care of Bayonet gender and lock pin side , as booth versions exist , pin male / bayonet male , and pin male / bayonet female .
I could share what I have measured for me and works for me with (heatwise) TD-100 and (Sensatemp) THERMOJET. Haven’t verified it with other handpieces as I’m still waiting for them.
!!!Maybe it’s wrong and work only with that thermojet!!!
First picture is the Intelliheat Station and how I have connected the handpieces and which resistance.
!! PIN numbering is not the original one from connector datasheet !!
And I drawed Thermistors everywhere but it’s of course not , inside tip a thermocouple…..
(TD-100 , easy to open handpiece to see which side the thermistor is. Or measure if temperature is stable , ~2600Ω and only +4Ω to wrong pin ).
At my thermojet I can’t measure if at Sensatemp connector switch is between 1 and 3 or 1 and 6 as it was a demolished handpiece and I already mounted a 8pin connector on it but easy to measure if you have any handpiece with switch.
Doesn’t know about cartridge tweezer , maybe it’s same as TD-100 and heaters in parallel with full wave and each with a diode to get a half , or maybe second heater is the middle pin
Will see when it’s here.