EEVblog #520 – Michael’s 3D Printer


Michael from the Melbourne Connected Community Hackerspace talks about his large build area modular dual independent extruder 3D printer design project.
Not much electronics talk here, it’s mostly about the hardware build.
http://www.hackmelbourne.org/‎
http://www.3dprinterbits.com.au/
As usual, if you don’t like this type of content, don’t watch it.

Forum HERE

About EEVblog

Check Also

EEVblog 1418 – The Most EMBARRASSING Repair!

This “Repair” of a Keysight DSOX1102G oscilloscope was a tad embarrassing… Forum: https://www.eevblog.com/forum/blog/eevblog-1418-the-most-embarrassing-repair/ Podcast: Download