hi
i want to know where i can find the latest firmware version for my atten 1102cal+, i've searched on their site but i didn't find a place to download the firmware.
can some one help me please?
then i opened the scope and discovered that is was a siglent model SDS1102CNL (ADS1102CAL+)
Can you please clarify how did you arrive at the conclusion that ADS1102CAL+ maps to SDS1102CNL? Is there a possibility that I can find an "SDSXXXXYYY" marking if I continue to disassemble the scope further? If so, where could I expect to see a marking like that?
Second question: on my scope, when you go to Utility/System Status, it says (among other things): "Product type: ADS1202CL+"; I'm guessing you had ADS1102CAL+ written here with the original firmware. What does your scope say there now, after being flashed with Siglent firmware?
you will not find information about models on the pcbs because many models uses the same board. mine uses the same board as yours.
...
Second question:
my Atten ADS1102CAL+ after the update to Siglent Firmware shows:
...
check if your dso firmware is something like: 1.02.06.02P15R2. one good point for you is that siglent have just one model of 1202 (SDS1202CNL) the L in case of siglent stands for wide screen.
Software version: 3.01.01.31R16
Hardware version: 10-61-2.4
Product type: ADS1202CL+
Obs. Remember that Atten don't supply firmware upgrades so if you upgrade to siglent firmware, it's a no way back trip. Don't do it if you haven't absolute sure that the firmware is good for your model !!!
hi
i want to know where i can find the latest firmware version for my atten 1102cal+, i've searched on their site but i didn't find a place to download the firmware.
can some one help me please?
Is the scope otherwise working fine?
(...),but i have a little concern because the hardware revision is always the same (10-61-3.3) not 11-61-3.3 like delacvi said in this thread.how can i upgrade the hardware version if it's possible?
Is the scope otherwise working fine?yes it is.
by the way i found a solution, by updating the cfg file provided with update.now every thing seems to be ok,but i have a little concern because the hardware revision is always the same (10-61-3.3) not 11-61-3.3 like delacvi said in this thread.how can i upgrade the hardware version if it's possible?
thank you in advance guys
In my case the Siglent boot screen only appeared after second reboot (or after loading the .cfg file + reboot ?)