« Reply #25 on: July 14, 2020, 05:08:55 pm »
On 2020-07-01 I mentioned some scripts and side projects around KiCad.
One of these side projects is to aid in copying pin table text from a datasheet into a spreadsheet, do some post processing, and then generate a KiCad schematic symbol from the spreadsheet.
I have not used this myself because the components I use are all low pin count.
Thanks! I’ve seen them but I’m new to Kicad. I’m starting to walk now. Once I start running, I’ll give them a try.
Logged
Fear does not stop death, it stops life.