There were several issues with the operation and display of that analyser than looked odd to me, especially on narrow RBW settings. Almost like the instrument isn't fully developed yet.
Some rough edges and I mentioned them, also some lack of features I had hoped to see.
Some of the technical commentary was strange in places as well. Not sure the test methods/conclusions were correct in places.
Easy to just say that. Last time you questioned my MXA tests and I explained why and how each test was done. How about asking a question instead of asserting? When I explained my MXA testing rationale I didn't see you come back and acknowledge it.
Also, several obvious issues/problems were ignored in the review. I think this was a very kind (almost like a marketing?) review of a product that was clearly showing a few rough edges.
Yes, as I type this I am rolling in the money R&S sent me.
However, it was great to see the insides of the analyser during the teardown but why no closeups of the RF sections?
Because that is how I chose to film it.
How quickly does it charge the battery? How long does it last on the battery?
Not only I showed the battery life at the beginning of the video, this information is readily available from datasheet.
How does the display perform in sunlight or on a very cold day? (stick it in a cold fridge to test this).
Did talk about the screen performance a little, but didn't stick it in the fridge.
How easy is it to hold and operate when wearing gloves? How well does the tilt stand work?
I specifically talked about both of these.
How fast can it sweep on a very narrow span?
Again, I specifically showed this during the tests.
Can it cope with a local strong signal/blocker and still display a small signal? How good is it at letting the operator know if there is overload or uncalibrated settings?
Again, showed some of this. Showed the warning to user when overload condition is detected.
The tone in the mystery/puzzle question at 29:50 is probably the suppressed carrier from the IQ modulator in the EXG sig gen.
Yes, LO leakage.
I have no problem with discussions and questions, that is the whole point of posting here. But somehow each time you reply to my posts there is a tone of hostility I really do not enjoy. If I am mistaken, I apologize.
PS: I still have to measure the 8GHz amplifier gain... Will do that soon I hope.