Tryed 2 RS232 USBs but nothing. hTerm only a lot of whatever.
Any ideas?
The header pins are true RS232 signalling +/- 12V so not 5V levels.
UCCM-P > SYSTEM:STATUS?
-------------------------------------------------------------------------------
090-03861-03 serial number W56091xxxxx firmware ver 1.0.0.2-01 LINK mode
-------------------------------------------------------------------------------
Reference Status __________________________ Reference Outputs _______________
Ref 8KHz 0: [LOS]
TFOM 9 FFOM 3
UCCM-P Status[WAIT FOR GPS]
>> GPS: [no ref]
ACQUISITION .............................................. [ GPS 1PPS Invalid ]
Tracking: 4 ____ Not Tracking: 7 ________ Time ____________________________
PRN El Az C/N PRN El Az GPS 00:10:37 [?] 06 JAN 1980
10 18 315 42 12 21 218 GPS Invalid: inacc position
20 22 279 35 13 44 146 ANT DLY +0.000E+00
23 28 283 42 14 Not OK Position ________________________
24 56 286 36 15 66 208 MODE Survey: 0% complete
17 36 95 Suspended: poor geometry
19 30 121 INIT LAT N 49:XX:XX.952
28 32 51 INIT LON E 8:XX:XX.028
INIT HGT +0.00 m (MSL)
ELEV MASK 5 deg
-------------------------------------------------------------------------------
Command Complete
UCCM-P >
UCCM-P > POSSTATus
-----------------------------------------------------------------------------
11/28/2020 19:48:32
-----------------------------------------------------------------------------
Position : LAT(N 49:XX:X.222) LON(E 8:XX:XX.732) H(1XX.10 m MSL)
-----------------------------------------------------------------------------
Geometry : PDOP(0.0) HDOP(46.1) VDOP(46.1)
-----------------------------------------------------------------------------
Channel Status
num of visible sats > 9
num of sats tracked > 3
------ Receiver Channel State ------
CH 0 > SateID(25) TrackMode(pos avail) SigValue(31)
CH 1 > SateID(31) TrackMode(pos avail) SigValue(33)
CH 2 > SateID(32) TrackMode(pos avail) SigValue(37)
CH 3 > SateID(0) TrackMode(code search) SigValue(0)
CH 4 > SateID(0) TrackMode(code search) SigValue(0)
CH 5 > SateID(0) TrackMode(code search) SigValue(0)
CH 6 > SateID(0) TrackMode(code search) SigValue(0)
CH 7 > SateID(0) TrackMode(code search) SigValue(0)
CH 8 > SateID(0) TrackMode(code search) SigValue(0)
CH 9 > SateID(0) TrackMode(code search) SigValue(0)
CH 10 > SateID(0) TrackMode(code search) SigValue(0)
CH 11 > SateID(0) TrackMode(code search) SigValue(0)
-----------------------------------------------------------------------------
Rcvr Status(1) :
-----------------------------------------------------------------------------
Antenna Voltage: 5059 mV, Antenna Current: 18 mA
-----------------------------------------------------------------------------
Command Complete
UCCM-P >
Survey: 7.7% complete
Suspended: poor geometry