Start at frequency 50KHz and span 10KHz and set the RBW to 1HZ
Leave the RBW at 1Hz and set the frequency to 100MHz and the span to 1MHz.
Go back to RBW, it stays 1Hz ok and I can also change the RBW up and back down to 1Hz no issue.
Edit, I just had my ah ha moment. I went to take pictures so I could show what I was doing and realized that when I set span to 1 MHz, it was staying at 10KHz. No error message.
I guess all is good in the world again.
Joel
Hi to community,
i am wonder how you get manages the problem within file management system - inability to delete files?
It can't be that this bother only me?
Is it some way to resolve this?
Yes, the deletion of saved files is not obvious but is outlined in the User manual in the Files section on P67: 2.5.3.9 Operate
Simply, when in File UI select/highlight the file or folder and use the Operate softkey where then the Delete option becomes available for use.
Edit.
After further thought "Operate" as a selection to enter the deeper file management UI could be changed to Operator which IMO will be a more intuitive name for it as it suggests further file management possibilities.
I'll suggest this change to Siglent.
QuoteYes, the deletion of saved files is not obvious but is outlined in the User manual in the Files section on P67: 2.5.3.9 Operate
Simply, when in File UI select/highlight the file or folder and use the Operate softkey where then the Delete option becomes available for use.
Edit.
After further thought "Operate" as a selection to enter the deeper file management UI could be changed to Operator which IMO will be a more intuitive name for it as it suggests further file management possibilities.
I'll suggest this change to Siglent.
Thanks tautech,
unfortunately, it seems that my SSA has a life of its own.
For some files deleting was successful (first i must rename the file, until only .jpg remains - and than i can delete), for some not!
Anyway, file management remain wired - maybe some days Siglent would resolve that.
2) Reflection measurement (selected as "mode") is unusuable; starting the measurement by entering in this mode, the "reset" and "Cal open load" don't perform the appropriate functions.
So a rollback to 1.2.8.3 was executed waiting for a new FW release.
I have created a short video but can't upload(MP4).
Anyway, i can't even create a new folder in SSA alone.
If i understand all right, file manipulation is possible on SSA alone too,
or i have completely misunderstood, and file management is possible only with USB stick.
(With USB stick - is, in my case, possible every operation.)
I just discovered that the situation is far worse than I thought. Firmware is 1.2.8.2. My initial test this morning was:
1) power on
2) set start and stop at 88-107 MHz
3) set attenuator to 0 dB
4) select Pk-Pk
5) display reports marker @ 1.19 MHz !!!!!
6) select left Pk
7) display reports marker @ 343 KHz !!!
repeatedly selecting Pk-Pk results in the marker frequency reported @ random values including -1.99 MHz!!!!!
I've attached a JPEG of the last result. I took other pics showing the marker reported at a variety of frequencies all outside the sweep range with the maker located in the same spot.
I had lots of strange results earlier, but I just put that down to unfamiliarity. But with the marker staying in the same spot and absurd frequencies being reported on screen this thing is clearly not trustworthy.
The specs looked very attractive, so I found it odd that places that were carrying it had discontinued it. I think the reason is becoming clear.
I think the reason is becoming clear.