1
Manufacturing & Assembly / Re: Fellow LPKF equipment users?
« Last post by Jay_Diddy_B on Today at 01:59:12 am »Hi! I'm a Protomat S42 owner, hopefully soon to be operator.
@rodsolder, my machine came second-hand with a few boxes from Think & Tinker's bits, available from Colorado, USA, at https://www.precisebits.com/ . I haven't gotten my machine up so can't vouch for them, but they are cheaper than LPKF bits.
I have been using these bits for the last 10 years in my protomat c60. They are great. Highly recommended.
The c60 doesn't use the depth collars so the bits have to be the correct length. Some of the low cost bits I have bought from eBay have been the wrong length.
Regards,
Jay_Diddy_B