1
Other Equipment & Products / Re: NO DIY repair for you (festool rotex)
« Last post by kripton2035 on Today at 01:39:47 pm »so, to finally close this topic ...
I ordered a replacement board from festool, for some 140€ with shipping... and it was not the culprit !!!!!!
the small jst connector at the top of the board goes to a ntc inside the motor cage, that is inside the cage and not removable
(for the record the jst is NOT at a standard pin spaces, at least I did not have the same in stock)
so I cutted the ntc cable, soldered another 100Ω ntc, and voilà... now it's working
it was only some 10cts component that was faulty.
hope this may help someone else.
I ordered a replacement board from festool, for some 140€ with shipping... and it was not the culprit !!!!!!
the small jst connector at the top of the board goes to a ntc inside the motor cage, that is inside the cage and not removable
(for the record the jst is NOT at a standard pin spaces, at least I did not have the same in stock)
so I cutted the ntc cable, soldered another 100Ω ntc, and voilà... now it's working
it was only some 10cts component that was faulty.
hope this may help someone else.