1
Repair / Re: Laser Level Charger PCB ID
« Last post by Shaky on Today at 03:36:24 pm »Well, all I can say is WOW ! Thanks for the comprehensive reply @globoy but unfortunately, it looks like repair is way above my pay grade
All I have available to me is a mid-range digi multimeter, no scopes or anything like that. It was basically an attempt at trying to save a mate (who doesn't do anything electrical at all, let alone electronics) a few quid
If it helps, the wall-wart outputs 5v, the battery is showing 3.6v but there is 0 volts on the + & - brass pins on the pack. Funnily enough, there is 3.6v between the - & the Y pin, which made me think it was just a simple charger/bms.
Ah well, I'll let him know that he'll have to wait for the packs to come back in stock.
Thanks again for the reply, it's appreciated.
All I have available to me is a mid-range digi multimeter, no scopes or anything like that. It was basically an attempt at trying to save a mate (who doesn't do anything electrical at all, let alone electronics) a few quid
If it helps, the wall-wart outputs 5v, the battery is showing 3.6v but there is 0 volts on the + & - brass pins on the pack. Funnily enough, there is 3.6v between the - & the Y pin, which made me think it was just a simple charger/bms.
Ah well, I'll let him know that he'll have to wait for the packs to come back in stock.
Thanks again for the reply, it's appreciated.