1
Thermal Imaging / Re: Infiray XH09 X2 series, discussion
« Last post by Jane on Today at 02:49:20 pm »Anyone here uses this camera for electronics reparing?
Experience?
Experience?
I did read your explanation, but AGAIN you missed the fact that OP clarified before your first reply that the 20A input was NOT the actual maximum input current established by some empirical means, but a mystery number from a long-gone employee. The list of power supplies shown is the entire list of loads in the device. This was already explained to you by someone else and you STILL don’t seem to grasp it.Your first reply in this thread, long after OP had listed the part numbers of the power supplies used, you suggested 1. using a motor-generator set, and 2. to consider switching to an SMPS inside.
Both of those suggestions are completely irrelevant and useless at that point in the discussion because it had already been established that it uses two universal-input SMPSs.
This shows you did NOT read the discussion before replying.
When I posted my first reply in this topic I didn't seen complete list of power supplies which are used on OP device. And correct me if I'm wrong, there is still no such list. Also I noted in the first OP post that his device power consumption is about 2300 Watt. And two PSU which he later provided for example is about 750-900 Watt in total, which is just about 40% of total device power consumption. So there is no way to decide if all of his PSU are compatible with all mains standards. I already explained it, but for some reason you're didn't read it.
See the difference on the 2 flip-flops the one with clk will only change data on posedge of the clk the other will do as long enable are valid[
If you use Quartus and have made a schematic, then while the schematic are selected you can click "File"/"Create/Update"/"Create HDL Design File from current file" (the schematic) select verilog, give it a name, quartus will then make a verilog version of your schematic.
Thanks, I did it.I have these other two KiCad symbols that I'm try to identify, are they a D flip flop and a D latch with enable?Not sure though.
lets wait HAM fellows (names with numbers and who build their own radio) to chime in what they have to say