1
Metrology / Re: Yet Another Hammon Divider (YAHD)
« Last post by thermistor-guy on Today at 07:25:17 am ».... Also, be sure to use hemostats or some kind of heatsink when you solder them, lest they change value by more than you might think!
Good idea in principle. Another point: after soldering, give the resistor network a day or two to settle (unpowered).
I've had a situation where some cheap metal film resistor networks I made were way out of tolerance soon after soldering,
but measured almost exactly right the next day. I thought I'd ruined the networks, by soldering them without a heatsink,
but no - they turned out fine.