The "Self Calibration" function does fail at "self calibration step (13/34)" with message "Self calibration failed, error x502".
- The Save Wave button always saves to USB, regardless of the Media settings; is this a bug or normal?is there a way to select SD as destination? if not, then it is not a bug, if yes - well, then it is bug.
I am interested in MSO5074F oscilloscopes. Does it with the USB interface?
So I picked up a DSO5072P over the last summer, put it through it's paces for a few days, and then did the 200MHz upgrade... Now the probe test output is reading as a 0.188V@1kHz square wave, and the self-calibration fails at step 2 with the error code 0xa00... Anything I can do to fix this, or is it hosed?
Hello!
I did revice my Hantek DSO5102P yesterday, it's a 100mhz oscilloscope
It's running fw: 3.40
Is there any 200mhz hack for it?
I did read first post in this thread and did make backup of mtd blocks.
Now im connect to uart pins directly beside usb port on the backside.
i got console now, and could see file dst 1102b i did raname it to dst1202b
is that all? =/
Hi again, did try to make own disp file with image2lcd with info from readme file included, but after reboot it's still same as original
Did place disp file in /dso/app/
Hi,
I'm new here and have a Hantek DSO1102BV (hw version: 0x555583e8, SN: DSO0501xxx, PCB marking: DSO1000H v.1.00.1).
I haven't changed anything yet, except for a fw upgrade from 2.01.1 (120701) to 2.01.1 (130129).
After having read through the forum, I have several questions:
- I'm a bit puzzled by the Wave and Save Wave submenus under SAVE/RECALL: setting Media to USB or Flash, Save and Recall work as expected, but Recall fails when Media is set to SD even though Save succeeds according to the message. The SD card status is "built in"; is the "EEPROM licensing hack" still needed if I want to use the SD card for saving waveforms?
- The Save Wave button always saves to USB, regardless of the Media settings; is this a bug or normal?
- The UART header is marked differently on two pictures (RX and TX are swapped,
https://www.eevblog.com/forum/testgear/hantek-tekway-dso-hack-get-200mhz-bw-for-free/?action=dlattach;attach=50483 vs.
https://www.eevblog.com/forum/testgear/hantek-tekway-dso-hack-get-200mhz-bw-for-free/?action=dlattach;attach=19887 ). Ok, one is the pinout of the DSO itself, and the other of the module to be connected, but which is which?
- Beside the UART header, there is a four hole connector marked @WLAN. What module can be used there?
Thanks for all the useful info already here, and any answers to come, cheers
Hello! I found Hantek has a update firmware can Recall when Media is set to SD.
anyone know, 5072P can be cracked?
hello, anyone have a 2Gsa/s sample rate, 60Mhz DSO7000 series?this series looks just launch.