I will add a new option to select the NTC type!
Then the handle NTC resistor is different. The current NTC look-up table is for 10K NTC.
But I know there are stations using 100K NTC.
Looks like the setting to disable button standby doesn't work.
I have the following settings:
- btn slp ON
- btn stby OFF
but when pressing encoder+left it will still cycle through standby then sleep.
V1.5 on today's build.
On a more general note, I believe the previous PID values or maybe the algorithm were better (I used a 3 days old build before). I just can't calibrate some tips properly, the result is always off by +30~+50°C even though calibration values come out very similar when I retry. Admittedly, I only tried with 2 tips and the second one isn't that bad (within 10~15°).
Then the handle NTC resistor is different. The current NTC look-up table is for 10K NTC.
But I know there are stations using 100K NTC.I can't wait tomorrow and checked it. You are absolutelly right!
One handle (yellow-blu) have right amb.temp, another ("Quecoo") have wrong.
And yellow-blu NTC=7.5K. "Quicoo" have 77K
Looks like the setting to disable button standby doesn't work.
I have the following settings:
- btn slp ON
- btn stby OFF
but when pressing encoder+left it will still cycle through standby then sleep.
V1.5 on today's build.
On a more general note, I believe the previous PID values or maybe the algorithm were better (I used a 3 days old build before). I just can't calibrate some tips properly, the result is always off by +30~+50°C even though calibration values come out very similar when I retry. Admittedly, I only tried with 2 tips and the second one isn't that bad (within 10~15°).
Button sleep / standby options disable button wake, doesn't affect manual mode. That's how its supposed to be and won't be changed.
If you disable both the station will never wake up!
Btn Slp = ON/OFF
Btn Stby = ON/OFF
Shake Slp = ON/OFF
Shake Stby = ON/OFF
Consolidate the menus into two like soBtn Wake = BOTH/SLP/STBY
Shake Wake = BOTH/SLP/STBY
This reduces the menu by 2 items and it will prevent a scenario that would disable wake all togetherDo these pictures suggest how I can get to your very well behaved temperatures?
Ignoring the spikes, what are the real temps in the tip?
Must he a hardware-related issue. I have 10 tips of all shapes, and they all work perfect with the same pid.
Your temperatures seem very well behaved. I flashed 2021-08-03b and I'm having a very different experience. Of course, after flashing I did a full reset. I've attached some pictures of the temperature graph of each of my tips. They are in order BC2, D24, Ku, C4, and my one wild tip ILS. I did notice that after changing tips the temperature graph would start going really fast. I could clear that condition by going into the menu and exiting. After that the graph was the normal speed. I haven't tried to modify the PID values from the reset. Do these pictures suggest how I can get to your very well behaved temperatures?