Hi,
Can anyone provide instructions on how to convert KSGER 2.1 station to support T245 handle?
I have attached a photo of my board.
Thank you.
cut r11 trace
Ok. Is this correct? Where should I connect TC+, to NTC?
watch the trace nearby r11 and ull see special pin dedicated to jbc tc+ (lowest in 6 rake)
T12 has heater and thermocouple in serial.
That trace that you need to cut is to split power (+24V) and input of U3 amplifier (this is to know what is the temperature on the thermocouple).
I hope I explained it clearly. If not, just ask.
So you need to connect TC+ to JBC (also where is says: "this trace wrong on some boards"). So your thermocouple will go to R12D (pin 5).
Everything understandable?
EDIT: I guess I was a little bit too slow
Meh, the cheap 75W rarely handles that, usually it resets or greatly reduces the voltage.
Try it, if it goes bad then get a better PSU.
one of the ones i received that looks like that one has an stc not stm on the board
It's actually written on the product page:
- Using STC15W408A5 microcontroller,
- Use sGM855xN high precision op amp,
Yeah, it seems very unlikely that someone would make a clone on a completely different microcontroller and bother recreating the same firmware. Most certainly they are all using STC.
Now, that chip may be enough for its purpose but that's a definite rock bottom downgrade for anyone wanting to hack it.
Hmm and the Quicko T12-958 seems to be a KSGERv3-compatible.
vulkan over at dangerous prototypes put the unisolder into the ksger style case as a lite version now looks like
Hi,
Can anyone provide instructions on how to convert KSGER 3.1s station to support T245 (C245) JBC handle?
I have attached a photo of my board.
HELP
cut at x mark. solder at bolb mark
Then follow this connection.
Edit: Also added pcb picture just to annoy Wickated
just to annoy Wickated
noone complaining bout FW ? im still on like september build and feels ok.
There aren't big changes, just minor gui bugfixes you'll rarely encounter.
The settings structure isn't changed, you could update right away keeping everything.
Just in case, make a backup of the flash...
ma soft suck...
standby time (manual option) minimal is 1 minute....
How I can change soft?
my processor is MindMotion MM32SPIN27PF not stm32...
Stlink cant read processor…
I connect 3.3v gnd swdio swclk and cant read