I had a dead battery, I disabled the option itself in the settings for now, they just run out pretty quickly for me, I need to think about what’s wrong.
Some boards put a 10K resistor between Vbat pin and gnd, it's useless and only drains the battery.
Ok, I'll look at the diagram of my station, thanks for the advice!
Is it possible to add the Spanish language? I can do the translation
I'm spanish myself!
There's no spanish translation because most labels/options are simply too long.
Try yourself, you'll see the end result is awful.
hello, i have quicko t12 942, its stm32, i dont know if ita fake or not, i linked a yt video , credit to the owner, its exactly the same as mine
https://youtu.be/xzv6Tvg-ZqY
hello, i have quicko t12 942, its stm32, i dont know if ita fake or not, i linked a yt video , credit to the owner, its exactly the same as mine
https://youtu.be/xzv6Tvg-ZqY
That station uses STC not stm32?
So as i can see, i can use the firmware or not? I am not sure.
No idea, those pictures don't help all, PSU is irrelevant.
Compare with
other schematics.
That T12-942 is lot supported and will never be, too small stm32.
I said no, it's too small!
Hello. Can somebody tell me, where i need to connect the ST-link? BR
GitHub Readme, programming. Please read a bit before asking the same questions!
do you think we ask for more here if github guide answer allbour questions? terrible
Correct I read everything. But I am not sure because of so many boards where I need to connect. BR
Your PCB has nice silkscreen, just look at the connector with CLK, DIO, GND.
do you think we ask for more here if github guide answer allbour questions? terrible
Don't you know how to trace connections with a multimeter?
Hi David, in case it helps you, apparently I have another damn clone and I've had this station for years and it's not "recent"
Hello. I flashed my handskid station. I only have the problem with the NTC and I don’t know what else I can du. On the other soldering station with original firmware, the soldering iron works. Inside ist the board V2.7. Maybe know somebody the problem. Also when I switch off the NTC, its still the same alarm. Br
Probably fake stm32. Try clone fix option in system menu.
That option was bugged and wouldn't be applied unless other system option was also changed, so for example also change Debug option at the same time.
Hello David. When both is off, he shows me 24,9V an the problem with NTC Problem. When i switch them on, there in not anymore the problem with the NTC but he shows me, that the voltage is to low. Something arround 15 V.
If you disable NTC It will use the internal sensor. Is this still fails, it's a fake stm32.