• \n \n
  • EEVblog #607 – Agilent B2912A Source Measure Unit SMU Teardown

    What’s inside a $13K Agilent Source Measure Unit capable of 15fA and 100nV resolution? Plus triaxial cables, and low current measurement connection. Data Sheet Connection Guide Component Datasheets: FDS8978 Dual MOSFET OPA1611 Audio Opamp ISO7240A Isolators ADS8202 Diff Amp ADS1675 24bit ADC 30N06 MOSFET Forum HERE High Resolution Teardown Photos: …

    Read More »

    EEVblog #606 – Mailbag

    Dave flips the bird. A 1970’s Mattel car racing game. Sex on a stick multimeter probes. Sagan, Mrs EEVblog, and a whole lot more in today’s Mailbag Monday Bob Widlar poster Easy EDA Channel Engineer on Youtube We Make Things http://felitek.de/ http://www.probemaster.com/ Forum HERE Podcast: Download

    Read More »

    EEVblog #605 – Fig.8 & Cardioid Microphone Patterns

    Doug Ford, former head designer from Rode Microphones continues with Part 2 of the microphone technology series by explaining the construction of noise cancelling Figure 8, cardioid, and hyper cardioid microphones. Also, how the polar patterns and responses relate to the physical construction, and how the frequency response is affected. …

    Read More »

    EEVblog Server Issues

    The EEVblog dedicated server which hosts this site and the forum went down for most of today. It was not a fault of the server itself, but a major outage for all dedicated servers hosted with HostGater, the company I use that provides the server. Here is some info Sorry …

    Read More »

    EEVblog #603 – Gas Sensor Teardown – Dräger Multiwarn II

    What’s inside a Dräger Multiwarn II gas detection warning system used in mining, oil, chemical, and emergency services etc to detect hazardous or explosive atmospheres. Intrinsic safety design and how both catalytic bead and infrared IR gas detectors work, and pellistors. And a teardown of a Hydrogen Sulfide (H2S) sensor. …

    Read More »

    EEVblog #602 – Introduction to Microphones

    In the first of a series of videos tutorials on microphones, Doug Ford, former head designer at Rode Microphones explains the basics of how microphones work, the different types – carbon, dynamic, ribbon, condensor/electret, and how the omnidirectional pattern works. Also, the internal construction of a high end measurement microphone. …

    Read More »

    EEVblog #601 – Why Digital Oscilloscopes Appear Noisy

    Why do digital oscilloscopes appear noisier than traditional analog oscilloscopes? Dave busts the myth that digital scopes are noiser than analog scopes, and demonstrates what inherent advantages digital scopes can have over analog scopes in terms of true waveform capture. And also why your analog scope may be hiding important …

    Read More »

    EEVblog #600 – Opamps Explained

    The most often requested video! Dave explains what Operational Amplifiers (OpAmps) are and how they work. The concepts of negative feedback, open loop gain, virtual grounds and opamp action. The comparator, the buffer, the inverting and non-inverting amplifiers, the differential amplifier, and the integrator circuit configurations are also explained. Then …

    Read More »

    EEVblog #597 – Fluke 114 Kit Multimeter + Sparkfun/Fluke Rant

    Fluke 114/117 Kit Multimeter for hackers, makers, and hobbyists. Tweet @FlukeCorp if you want to get on the list for one: Use the hashtag #FlukeKit Or ask on their Facebook page Dave comments on the Sparkfun/Fluke multimeter customs trademark/trade dress fiasco, and shows off the new low cost Fluke 114/117 …

    Read More »