KedasProbe, Thanks for the information, I went to the page you posted, and I show no licenses.
This information just made the the whole thing worst. First and foremost, I did not move the software, that was my grounds for asking for a new KEY, second the "Product Line Manager for Kickstart software" was involved, and they did not mention this as a possible solution, or at all. So if it is a possibility, and they should know that it is, they are knowingly trying to get me to pay for the license I already have.
Thank you for your order number ******* (Purchase Order:DMM6500: Free KickStart) of 1 new software licenses for your Tektronix products. Included in this email are instructions on how to obtain those license keys.
Here is a list of the products purchased on this order:
1 - KICKSTARTFL-BASE License; KickStartFL-BASE for all base apps of KickStart 2.0; Floating
To manage the Check In and Check Out process, we have developed TekAMS, a free, web-based application available using your tek.com account. Access TekAMS at the following URL:
http://www.tek.com/products/product-license
After you login, enter the Software License application by clicking on the "Software License" link at the top of the page, then click on the "Redeem a Claim Check" link on the page and enter your personalized code:
****** (case-sensitive)
This claim check is only good for 1 year and is specific to a MyTek account with the user name of *****@telenet.be. Please redeem your claim check now.
After you have redeemed your claim check, you will have full access to check out and check in your floating licenses using this TekAMS application.
http://www.tek.com/products/product-license
Thanks for buying Tektronix!
When I go to the License Manager Home page, In big bold letters it has "No Active Customer Relationship", sound about right
It never did get resolved, I just put on my big boy pants and did everything in python/scpi.
.......(Other than worrying about Tek being dicks about this means they will be about other stuff?)
@Pinörkel Same here with the screen. (Didn't notice, because I have it stacked to about eye level on my bench).
I would say viewing angle left to right on center high or slightly above is very good.
Being directly in front of the device and looking from below is also very good.
Screen quality (doubling/ghosting) is getting worse when looking from an angle from below.
Looking at the screen from above is worst. I start to notice it getting worse from 10 deg, at 45 deg straight it really bad.
Looking from top and the side seems to be better again.
Sorry no pictures due to poor lighting in that corner of my desk
But I don't think mine is different to your pictures.
No questions asked. The return documentation said something like "31dB when off, 34dB when on, spec is 40dB so it's ok" but now it doesn't hum anymore so I guess they fixed it?
Is there a KICKSTARTFL-BASE lifetime License included from welectron?
Yup. It is going overseas to be dismantled.
I want to use the DC ratio function to measure the current amplification (at 180 μA) and measure Vbe using a scope to be able to match pnp transistors on those parameters using the posted test circuit. (The transistors will be used in a current mirror configuration.)
However my current measurement resistor for the base current is 1M. The question is how high is the input impedance of the sense terminals when doing a measurement on the 10V range?
I know the sense measurement range is fixed at 10V, so the 1M resistor is intended for keeping the resolution high.
Swapping sense en input (and selecting a lower range), would lead to the issue of not be able to measure the collector current sense voltage to fine tune that current by changing VCC.