It would be interesting (at least to me) to know if these newly-received DS1054Z scopes can reproduce some of the various bugs that we've noticed.This is not the newest FW !
Please update to SP1 and repeat the check.
It would be interesting (at least to me) to know if these newly-received DS1054Z scopes can reproduce some of the various bugs that we've noticed.This is not the newest FW !
Please update to SP1 and repeat the check.
LG Wolfgang
Model:DS1104Z
SN:DS1ZA170300673
Manufacturer:RIGOL TECHNOLOGIES
Board Ver:0.1.1
Firmware Ver:0.2.3.11
BOOT Ver:0.0.1.2
CPLD Ver:1.1
SoftWare Ver:00.04.03.SP1
How I include the youtube code here ?
<iframe width="640" height="360" src="https://www.youtube.com/embed/0xSdAz_Phm8" frameborder="0" allowfullscreen></iframe>
I meant same like alsetalokin4017 did it here..
https://www.eevblog.com/forum/testgear/new-rigol-ds1054z-oscilloscope/msg781316/#msg781316
[url]https://www.youtube.com/watch?v=0xSdAz_Phm8[/url]
Hello,
is this a new unknown bug?
At TRIGGER MENU > Settings > Coupling ...
At DC and HFR the Trigger-Level-Display is ok.
At AC and LFR the T-Symbol and Line disappear.
At TRIGGER MENU > Settings > Coupling ...
At DC and HFR the Trigger-Level-Display is ok.
At AC and LFR the T-Symbol and Line disappear.
This is intentional, in my understanding: When the trigger is AC coupled, there is no absolute trigger level, hence there is nothing to display.
Yes, if the TRIGGER-Source is AC, then it's possible ok.
NO, when you set the TRIGGER-Coupling to AC, you can vary the Trigger-Level - check it!
It makes sense!
My old TEK TDS210 shows in all 4 Modes (DC,AC,LRF,HRF) the Trigger-Level and let ist vary.
LG Wolfgang
is this a new unknown bug?
PS: 00.04.03.SP1
@alsetalokin4017
I can not repoduce your math and trigger errors. All of them working fine with the 00.04.03.SP1 firmware.
Please can you send me your scope-setup files so I can check it again ? Maybe your setup was wrong at your measurments.
The only issue I have is the persist 100ms / memory bug with the hang up. Please someone else can check the persist / memory error with the hanging up ? Shown in the video few posts up.
/Edit
okay, forget it, found the Bug/wishlist thread here: https://www.eevblog.com/forum/testgear/rigol-ds1000z-series-(ds1054z-ds1074z-ds1104z-and-s-models)-bugswish-list/
With the latest firmware installed, the scope still freezes with the 2GB drive, but is fine with the 512MB. Both use FAT16.
The manual doesn't specify anything about compatible USB storage devices. Is there a maximum size?
It is recommended that the capacity of the USB storage device being used with this oscilloscope is no larger than 8 GBytes.
I have used a Corsair 32GB FAT32 formatted stick to update a DS1045Z without any problems.
Also, I used a Kingston 16GB FAT32 formatted stick with a clusterzise of 16384 bytes to update a DS6104 without any problems.